@nickkincanon wrote:
I’m admittedly a newbie, but is it possible that my LVDS connector is upside down on my display board? I’ve compared it to other pictures on the web, and it doesn’t look the same. The black connector piece is on the bottom side, which means that the ribbon is too short, and I would have to twist it 180 degrees to input the ribbon blue side up on the board and connect the other side into the display. I tried to connect the ribbon to the top side, but that didn’t seem to make sense. Of course, while trying to figure out how this works, even after trying to be gentle, the bottom black piece snapped off. I purchased this kit from Amazon. I’ve attached a few pictures. Any ideas? Otherwise, is it possible to buy a replacement board? Thanks!
Posts: 7
Participants: 4